BODYGUARD WOOD PRODUCTS (8160-2022:0007) — eave assembly section.
Drawn from this record's own sourced values; every dimension on it is one a
published document states, and a parameter the source did not publish is
named on the drawing rather than estimated.
The profile is traced from the manufacturer's own dimensioned drawing, reviewed and signed. CC BY 4.0.
BODYGUARD WOOD PRODUCTS (8160-2022:0007)
This is a listed eave assembly. Listing 8160-2022:0007. This site cites OSFM BML. Match the model and orientation.
BODYGUARD WOOD PRODUCTS listing 8160-2022:0007 in OSFM category 8160. “Bodyguard® #802” tongue and groove, pressure treated pine, minimum 3/4” thick x 5-7/16” wide (nominal 1” x 6”), installed over 1/2” regular gypsum board. Refer to the manufacturer's installation instructions and product data sheets.
One drawn shape serving two patterns through an A/B/C/D table, so it is schematic and nothing on it may be scaled — its drawn aspect is 6.45 to 1 against pattern 802's 7.86. Row 802 is this record's pattern. BOTH DIMENSIONS ARE PUBLISHED CONFLICTS; lane INGEST-C wrote the conflict rows on 2026-08-28 and the winning values with them. The listing states a MINIMUM 3/4 inch thickness and this sheet's C is 11/16 inch, so the current pattern is drawn BELOW the thickness the listed assembly requires — the sharper half of the conflict, because it is not two measurements of one thing but a product outside its own listing's floor. The listing's 5-7/16 inch width is likewise neither A (5-13/32 inch) nor B (5-1/16 inch). The sheet also fails to close on itself for this pattern: the fixed printed 3/16 inch shoulders plus D (1/4 inch) is 5/8 inch against a printed C of 11/16 inch. It closes exactly for pattern 801, drawn from the same lettered diagram.
